FORDification.com
   (powered by Google)

  HOME

  Technical Articles

  Factory Literature

  Discussion Forums

  Photo Galleries

  The BumpWiki

  Service Bulletins (TSBs)

  Decoding Your VIN

  Diagrams & Schematics

  Links & Resources

  In the Movies

  Downloads
  Member Meet & Greets

  In the Media

  Site Index

 MISC / PERSONAL

  My Truck Projects

  My Heinz 57 '67

  I've Been Censored!

  Contact



‹ Back to Technical Index

"Poor Man's 427"  -  Page 03

by Wes Adams

Part One of the Sleeves on the Poor Man's 427!

December 10, 2004 at 1:03 AM
 http://www.network54.com/Forum/74182/message/1102669401/
This is what we are using for sleeves! The block got punched out to 4.500" and the sleeves are 4.503".
 
Here is what it looks like with the sleeve in the hole, looking from the bottom up.
 
This is from the top down.
 
Here is what it will look like.
 
NICE TIGHT FIT. That's the way I like it.
 

In Part 2 I'll tell you how we put in the sleeves. I hope you enjoy all of this. Even if you don't, I sure do!

 

first  previous

next   last

 

|  Home  |  ‹ Back to Poor Man's 427 Index  |
 

 


Want to link to this site? Please save this banner to your hard drive to place on your webpage.
The correct link to use is http://www.fordification.com

Copyright library© 1999-2019 FORDification.com unless otherwise noted. All rights reserved.
All brand names and product names used on this website are trade names, service marks or registered trademarks of their respective holders.  
No portion or content of this site may be reproduced or otherwise used without explicit permission.
 To report problems or provide comments or suggestions, please click here.