|
|
|
1967-1972 Ford F-series Pickups FAQs |
|
"Poor
Man's 427" - Page 06
by
Wes Adams |
|
|
WEBMASTER'S NOTE: The following is an ongoing project
by Wes Adams to build a "Poor Man's 427", using a Ford FT 330 block
and other 'cast-off' parts. The posts were saved from the FordFE.com forums
and reposted here with Wes' permission. |
Some more new parts came in
for "The Poor Man's 427"~
January 7, 2005 at 12:09 AM
http://www.network54.com/Forum/message?forumid=74182&messageid=1105085349
I want to say thanks to these guys
Tommy-T, Warren, Ted Eaton, and a local guy name Richard. Here
is what we got:
This is a Roller cam that we got from Tommy-T here...what a cam!
It's kind of big for street use but that's what we like.
|
|
This is an Ed Street Master from Warren. Scott Vincent did some
port work to make this thing RUN! |
 |
 |
|
|
We got a Holley 1050 with a Wilson spacer from Richard (a local
guy in town here). Yes that's right...a 1050. The carb and spacer
are brand new! That's a lot of carb, but we'll use it.
|
|
Ted gave me a killer deal on a set of NEW pistons for my wife's
427. (That's later down the road, when this Poor Man's thing is
over and the '55 F-100 428 is done). |
 |
 |
|
|
Here we are comparing the NOS 427 piston (that Ted sold me) with
the Venolias (that Tommy-T donated for the Poor Man's 427). |
 |
|
Once again THANK YOU for making this possible to do. I can't wait
for the results on this when it's all said and done! |
|
Want to link to
this site? Please save this banner to your hard drive to place on your
webpage.
The correct link to use is
http://www.fordification.com
|
