FORDification - The 1967-1972 Ford Pickup Resource


	<ilayer src="IFRAME01.htm"> </ilayer>


	<ilayer src="IFRAME02.htm"> </ilayer>


	<ilayer src="IFRAME03.htm"> </ilayer>


	<ilayer src="IFRAME04.htm"> </ilayer>

*1967-1972 Ford F-series Pickups FAQs*
"Poor Man's 427" - Page 03 by Wes Adams

WEBMASTER'S NOTE: The following is an ongoing project by Wes Adams to build a "Poor Man's 427", using a Ford FT 330 block and other 'cast-off' parts. The posts were saved from the FordFE.com forums and reposted here with Wes' permission.

JUMP TO | INDEX | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 | 19 |

Part One of the Sleeves on the Poor Man's 427! December 10, 2004 at 1:03 AM http://www.network54.com/Forum/74182/message/1102669401/
This is what we are using for sleeves! The block got punched out to 4.500" and the sleeves are 4.503".
Here is what it looks like with the sleeve in the hole, looking from the bottom up.
This is from the top down.
Here is what it will look like.
NICE TIGHT FIT. That's the way I like it.
In Part 2 I'll tell you how we put in the sleeves. I hope you enjoy all of this. Even if you don't, I sure do!

JUMP TO | INDEX | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 | 19 |

Want to link to this site? Please save this banner to your hard drive to place on your webpage.
The correct link to use is http://www.fordification.com

Part One of the Sleeves on the Poor Man's 427!