Campbell Hausfeld 4 hp 220volt 20 gallon belt drive

dolinick · Post by **dolinick** » Mon Sep 10, 2007 12:21 am

I bought this air compressor from craig's list.
It came with a paint gun and ratchet. The hose
leaks. I practiced sandblasting on my lower valence
which is kind of rusty. I don't know if I'm going to
damage the sheet metal with the sand.

compressor
http://farm2.static.flickr.com/1243/135 ... 77a8e9.jpg
air gun
http://farm2.static.flickr.com/1121/135 ... 7cc301.jpg
motor(warning large picture)
http://farm2.static.flickr.com/1286/135 ... cd4f_o.jpg
lower valence (top)
http://farm2.static.flickr.com/1270/135 ... f951fc.jpg
lower valence (bottom)
http://farm2.static.flickr.com/1324/135 ... 23847a.jpg

Dan

Tim P. · Post by **Tim P.** » Mon Sep 10, 2007 6:15 am

Oooh valance not looking good might be able to save you,ll need a mig and a copper spoon to fill all thoses holes.

dolinick · Post by **dolinick** » Tue Sep 11, 2007 7:15 am

Tim P. wrote:Oooh valance not looking good might be able to save you,ll need a mig and a copper spoon to fill all thoses holes.

I have neither a mig or a copper spoon plus I can't weld.

Dan

Tim P. · Post by **Tim P.** » Tue Sep 11, 2007 5:35 pm

local weld shop could accomidate you. finding a better one are far and few between.

The FORDification.com Forums