Dana Spicer 44 front wheel drive hub lockout o-rings

Questions about 4WDs and related topics

Moderators: FORDification, Doug Comer

Post Reply
aelmo
New Member
New Member
Posts: 7
Joined: Thu Dec 25, 2014 6:24 pm

Dana Spicer 44 front wheel drive hub lockout o-rings

Post by aelmo »

I would like to share some information that may be helpful, or save time to others looking for
replacement o-rings for the Dana Spicer 44 front wheel drive hub lockout
referred to as spicer models 30 and 44 internal type front axle HUB LOK.
The smaller o-ring for the actuator knob is 2 Inch I.D. x 2-3/16 Inch O.D. x 3/32 Inch cs national o-ring part# NAT136
The larger o-ring for the retainer knob hub ring is 3-1/8 Inch I.D. x 3-3/8 Inch O.D. x 1/8 Inch cs national o-ring part# NAT235
These parts work for my 1968 Ford f100 4x4 with dana 44-7 front axle.
lockinghubsF100(3Kaxle).jpg
You do not have the required permissions to view the files attached to this post.
User avatar
Manny
Blue Oval Guru
Blue Oval Guru
Posts: 1190
Joined: Wed Oct 04, 2006 7:15 pm
Location: Georgia, Lake City
Contact:

Re: Dana Spicer 44 front wheel drive hub lockout o-rings

Post by Manny »

Thanks for the good info. That's a tough one to find. We appreciate the time you put into it to research it.
Just another Ford fool named Dan.
The Junk that hangs around
67' F-250 highboy Camper special cross breed currently under way
http://www.fordification.com/forum/view ... 22&t=86706
1974 Bronco 302 3 speed
1984 bronco 302 c6 35's
1994 F350 7.3 5spd dually.
woods wrote: The rust holes in my truck were a factory install (very rare).
Post Reply