I would like to replace the speedometer cable firewall seal in my 68 F100, 360/C6 truck. The speedometer cable has a foam rubber tube type seal at the firewall, and another longer one down more towards the transmission which I think is just to keep the speedo cable from rubbing on the body. The fittings on both ends of the speedo cable are female threads that go to the speedometer and transmission. I have found the foam rubber tube type firewall seal at LMC and CJPonyparts, but am wondering how you install it with the large metal fittings at each end of the cable? Does not seem like the seal will go over the fittings without ripping them. Looks like I'll have to cut the seal lengthwise with a razor knife, install on speedo cable, then glue seal back together. Any thoughts on a good glue that won't eat my new seal?
BumpWiki discussion, suggestions and assistance
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users