C notch question

Suspension, steering, brakes, wheels & tires

Moderator: FORDification

1967longbed
New Member
New Member
Posts: 4
Joined: Sat Jun 13, 2015 1:46 pm

C notch question

Postby 1967longbed » Thu Feb 15, 2018 11:54 pm

So I'm a long time reader, but new poster. I'm swapping in a 31 spline 9 inch into my 67 f100 long bed, and doing a axle flip putting it on top of the leaf springs. What are the measurements to locate where the c notch should go? I have 4.5" steel pipe, .25" wall. Thanks in advance for your help!
Red Seal Journeyman John Deere Technician

1967 Ford F-100 - FE352 V8, 3 speed manual, 2WD, long bed, custom cab.

Bronco_77
New Member
New Member
Posts: 116
Joined: Sun Mar 27, 2016 7:55 pm

Re: C notch question

Postby Bronco_77 » Sun Feb 18, 2018 3:55 pm

The easiest thing to do is mark dead center of your axle and then make that dead center of ur c notch. That's how I did mine and it worked out great. U may want to mark center of the original axle the change em and do ur hanger flip and recheck ur center with the changes
68 f100 390 3 speed on the collom G maw gave to me G paw drove in late 70s till late 80s
77 bronco 302 lifted 5.5 with 33s and rears cut
69 Mustang boss 302 clone bought when was 14 sold when was 28 to build house

User avatar
BobbyFord
100% FORDified!
100% FORDified!
Posts: 5289
Joined: Sun Feb 04, 2007 9:52 am
Location: Chatsworth, California

Re: C notch question

Postby BobbyFord » Tue Feb 20, 2018 8:48 pm

I'm not familiar with '67 frame. My '72 had a bumpstop directly over the axle tubes.

viewtopic.php?f=5&t=56337&st=0&sk=t&sd=a


Return to “Suspension / Steering / Brakes”

Who is online

Users browsing this forum: No registered users