Clutch quick connect

Clutch, transmission, rear axle

Moderators: FORDification, 70_F100

Post Reply
anotherfordguy
New Member
New Member
Posts: 4
Joined: Sun Jul 18, 2010 11:55 am

Clutch quick connect

Post by anotherfordguy »

Hey all, trying to get my bump finished and hit a road block. I swapped in 351w and ended up using a 93 M5R2. I had to custom build my long tubes and they pass right in front of the coupler to the slave cylinder. I need the hose to turn 90* up into a custom flex hose to the master. Where can I find a male quick connect that threads onto an aftermarket hose? Or what is the technical name of the coupler that I could look it up? Or any other ideas from someone that's battled this. Thanks a bunch.
User avatar
71PA_Highboy
Blue Oval Fanatic
Blue Oval Fanatic
Posts: 923
Joined: Tue May 23, 2006 11:32 am
Location: Denver of the East

Re: Clutch quick connect

Post by 71PA_Highboy »

It has been a while, but IIRC you can pull the hard line out of the slave cylinder and take it to a tubing shop and get a custom tube made. It is held in with a roll pin.

You have to remove the slave from the trans to do this.

Good Luck!
Got Ford?
2 EarlyBroncos (68,69)
2 Classic Mustangs (69,70)
1 F250 4x4 (71) - OB - 360, NP435, D24, HPD60 4.10, D60,
1 94 Ranger, 2.3, 5spd
1 Lincoln Mark VIII
Post Reply