Length of Front Driveshaft with C6?

Clutch, transmission, rear axle

Moderators: FORDification, 70_F100

Post Reply
User avatar
colnago
100% FORDified!
100% FORDified!
Posts: 1882
Joined: Tue Jun 14, 2011 8:48 pm
Location: Ridgecrest, CA

Length of Front Driveshaft with C6?

Post by colnago »

Okay, so I have a long-tail (automobile) C6 in my '67 F250. I'm rebuilding a different C6 in the garage, and I have both a long-tail and short-tail output shaft and output housing. I would rather go with the short-tail, but this would mean a new front driveshaft. I've looked at tons of numbers, and every new table just confuses me more. So, does anyone know the length of the front driveshaft when using a C6 transmission, and where the measurements are being taken? Yes, I've seen the page in the tech section, but it doesn’t show where the measurements are taken. Any help?

Joseph
"Sugar", my 1967 Ford F250 2WD Camper Special, 352FE, Ford iron "T" Intake with 1405 Edelbrock, Duraspark II Ignition, C6 transmission, front disc brake conversion.
Post Reply